How To Use Round Nose Pliers?

Use your right hand to control the cutting area of the pliers, and extend your little finger between the two pliers handles to press against them. Open the pliers head so that the pliers handles can be separated flexibly. Instructions for using pliers:
① In general, the strength of pliers is limited, so they cannot be used to perform tasks that cannot be achieved by ordinary hand force. Especially for smaller or ordinary pointed nose pliers, using them to bend high-strength bar material sheets may damage the jaws.
② A typical pliers have three cutting edges and can only be used to cut iron wire, not steel wire.
③ The handle of the pliers can only be held by hand and cannot be used to apply force by other methods.
What should be noted when using mini round nose pliers?
1. The use of pliers is operated with the right hand. Turn the jaws inward for easy control of the cutting area. Use your little finger to extend between the two pliers handles to press against them and open the pliers head. This way, the pliers handles can be separated flexibly.
2. The cutting edge of pliers can be used to cut the rubber or plastic insulation layer of soft wires.
3. The cutting edge of pliers can also be used to cut wires and iron wires. When cutting galvanized iron wire No. 8, use a blade to cut back and forth around the surface a few times, and then gently twist it to break the wire.
4. The cutting edge can also be used to cut harder metal wires such as wires and steel wires.
5. The insulated plastic tube of the pliers has a voltage resistance of over 500V, and with it, it can cut wires with electricity. Do not litter during use to avoid damaging the insulated plastic pipe.